Printhead (Sx410 Series) - Epson Stylus NX510 Service Manual

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510
9. Remove each switch button from the Panel Cover.
Mode SW button
OK SW button
Figure 4-136. Removing the Switch button
When installing the Panel Board, align the positioning holes
of the Panel Board with their positioning pins of the Panel
Housing as shown in
Tighten the screws in the order given in
When installing the Panel Unit, attach it without any gap with
the Upper Housing. (See
DISASSEMBLY/ASSEMBLY
Start SW button Power SW button
Panel SW button Stop SW button
Figure 4-135.
Figure 4-135.
Figure 4-30.)
Differences in Disassembling/Reassembling SX410 series

4.7.3 Printhead (SX410 series)

See the following because the disassembling/reassembling
C H E C K
procedures of the Printhead for NX510/SX210 series differ from
P O I N T
those of SX410 series.
NX510 series:
" 4.5.1 Printhead " (p113)
SX210 series:
" 4.8.3 Printhead (SX210 series) " (p158)
Parts/Components need to be removed in advance
Document Cover/ASF Cover/Scanner Unit/Panel Unit/Upper Housing
Removal procedure
1. Perform Step 1 to Step 8 of "4.5.1 Printhead
2. Remove the Head Cable Inner Cover according to the following procedure.
2-1. Release the rib A (x1) of the Head Cable Inner Cover from the cutout
(x1) of the CR Unit.
2-2. Release the tab (x1) of the Head Cable Inner Cover from the groove
(x1) of the CR Unit.
2-3. Release the rib B of the Head Cable Inner Cover from the cutout of
the CR Unit.
Step 2-1
Rib A and Cutout
Step 2-2
Tab and groove Rib B
Figure 4-137. Removing the Sub FFC Guide
Revision A
(p113)".
Head Cable Inner Cover
Cutout Step 2-3
150
Confidential