Epson Stylus NX510 Service Manual page 130

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510
When installing the Main Frame Assy, pay attention to the
following instructions.
1. Put the right part of the Upper Paper Guide under the
LD Roller Shaft as shown in the figure below.
2. Align the hook (x1) of the Frame Support with the
positioning hole (x1) of the Main Frame.
3. Align the hook (x1) of the ASF Unit with the positioning
hole (x1) of the Main Frame.
4. Align the guide pins (x2) of the Base Frame with the
positioning holes (x2) of the Main Frame.
4
Figure 4-80. Main Frame Assy
DISASSEMBLY/ASSEMBLY
Upper Paper Guide
1
LD Roller Shaft
3
2
4
Disassembling the Printer Mechanism
Tighten the screws in the order given in
Follow the steps below to install the Extension Spring 10.99 to
the Upper Paper Guide.
1. Attach the one end of the Extension Spring 10.99 to the
hook of the Upper Paper Guide.
2. Attach the other end of the Extension Spring 10.99 to the
hook of the Main Frame with longnose pliers.
Extension Spring 10.99
Hook
Figure 4-81. Installing the Extension Spring 10.99
Be sure to install the Grounding Spring referring to
4-70 and Figure 4-71.
Whenever the Main Frame is removed/replaced, the required
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out.
• Chapter 5 " ADJUSTMENT" (p.161)
After replacing the Main Frame, be sure to perform the
specified lubrication.
• Chapter 6 " MAINTENANCE" (p.175)
Revision A
Figure 4-79.
Hook
Figure
130
Confidential