Epson Stylus NX510 Service Manual page 64

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510
Occurrence
timing Detailed phenomenon
CR position
When turning on the power, the CR
Motor does not operate at all.
• Power on
• Anywhere
When turning on the power, the PF Motor
does not operate at all
TROUBLESHOOTING
Table 3-6. Check point for Fatal error according to each phenomenon
Defective
unit/part name
1. Check if the CR Motor Connector Cable is connected to
the connector on the Main Board Unit shown below.
NX510 series:
SX410/SX210 series: CN8
NX510 series
CR Motor
2. Check if the CR Motor Connector Cable is not damaged. 2. Replace the CR Motor with a new one.
3. Check if the CR Motor operates.
1. Check if the PF Motor Connector Cable is connected to
the connector on the Main Board Unit shown below.
NX510 series:
SX410/SX210 series: CN9
NX510 series
PF Motor
2. Check if the PF Motor Connector Cable is not damaged. 2. Replace the PF Motor with a new one.
3. Check if the PF Motor operates.
Error Indications and Fault Occurrence Causes
Check point
CN6
SX410/SX210 series
CN8
CN6
CR Motor Connector Cable
CN7
SX410/SX210 series
PF Motor Connector Cable
CN7
CN9
Revision A
Remedy
1. Connect the CR Motor Connector Cable to the
connector on the Main Board Unit shown
below.
NX510 series: CN6
SX410/SX210 series: CN8
3. Replace the CR Motor with a new one.
1. Connect the PF Motor Connector Cable to the
connector on the Main Board Unit shown
below.
NX510 series: CN7
SX410/SX210 series: CN9
3. Replace the PF Motor with a new one.
Confidential
64