Epson Stylus NX510 Service Manual page 114

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510
7. Disconnect the Head FFC (x1) that is connected to the CSIC Board.
8. Release the tabs (x2) securing the Holder Board Assy with a flathead
screwdriver or the like, and remove the Holder Board Assy upward.
Tabs
Figure 4-39. Removing the Holder Board Assy
9. Remove the Head Cable Inner Cover according to the following procedure.
9-1. Release the hook (x1) and release the rib (1) of the Head Cable Inner
Cover from the Carriage Unit by lifting upward.
9-2. Remove the Rib (2) of the Head Cable Inner Cover from the Carriage
Unit while sliding it in the direction of the arrow.
Head Cable Inner Cover
Rib (2)
Figure 4-40. Removing the Head Cable Inner Cover
DISASSEMBLY/ASSEMBLY
Holder Board Assy
Head FFC Connector
Rib (1)
Step 9-1
Hook
Step 9-2
Carriage Unit
Disassembling the Printer Mechanism
Do not touch or damage the nozzles or the ink supply needles of the
C A U T I O N
Printhead.
10. Remove the screws (x3) that secure the Printhead, and lift the Printhead with
longnose pliers.
1
3
Figure 4-41. Removing the Printhead (1)
11. Disconnect the Head FFC from the connectors (x3) of the Printhead, and
remove the Printhead.
Figure 4-42. Removing the Printhead (2)
Revision A
2
C.B.S. 2.5x8, F/Zn-3C (3±1kgfcm)
Printhead
Head FFC
114
Confidential