Toner Cartridge Smart Chip Contact Removal - Lexmark MS510 Service Manual

Installation note: After installing a new controller board, perform the printer configuration restoration. See
"Restoring the printer configuration after replacing the controller board" on page

Toner cartridge smart chip contact removal

1
Remove the right cover. See
Note: For MS610de, also remove the following:
a
Controller board shield. See
b
Controller board. See
2
Disconnect the cable JARW1 from the system board.
3
Remove the two screws (A).
4
Remove the two screws (B), and then detach the right cartridge guide.
Warning—Potential Damage: Do not cut or disconnect the cable at the rear of the right cartridge guide. Leave
the right cartridge guide dangling while performing the rest of the steps.
"Right cover removal" on page
"Controller board shield removal (MS610de)" on page
"Controller board removals" on page
A
Repair information
194.
200.
204
4514-6xx
159.
200.