Removable Media Address Jumper Positions - IBM iSeries 270 Service Manual

Sb2 and sb3 hardware

Hide thumbs Also See for iSeries 270:

Table of Contents

Figure 21. FC 5095 or FC 0595 Expansion I/O Tower - power and signal cables

Table 37. FC 5095 or FC 0595 Expansion I/O Tower - Power cables

PWRC01 CB1 to device backplanes DB1 and DB2

PWRC02 CB1 to Air moving devices (AMDs) B01, B02, B03, and B04

Table 38. FC 5095 or FC 0595 Expansion I/O Tower - Signal cables

CB1 to Device backplane (DB1, left/top)

CB1 to Device backplane (DB2, right/bottom)

Operation panel (NB1) to System unit backplane (CB1)

Removable media address jumper positions

For use by authorized service providers.

Note the following:

v On Models 270, 800, and 810, only devices in location D07 require address jumpers. Devices in

location D08 do not require address jumpers.

v On the Model 820, only devices in location D13 require address jumpers. Devices in location D14 do

not require address jumpers.

Hardware (Remove and Replace; Part Locations and Listings)

Show Quick Links

Table of Contents