Fc 5095, Fc 0595 - Covers; Fc 5095, Fc 0595 - Device Board - Db1 And Db2; Fc 5095, Fc 0595 - Disk Unit (Concurrent) - IBM iSeries 270 Service Manual

The 16-digit World-Wide Port-Name can also be determined by appending the digits "1000" to the
beginning of the 12-digit IEEE Address found on the tailstock label of the Fibre Channel IOA. Use the
ESS Web Interface User's Guide (SC26-7346) to update the World-Wide Port-Name in the host
configuration on the IBM 2105 ESS. The ESS Web Interface User's Guide can also be found at the
following URL: http://ssddom02.storage.ibm.com/disk/ess/documentation.html
This ends the procedure.

FC 5095, FC 0595 - Covers

For use by authorized service providers.
Use this procedure to remove or replace the covers on an FC 5095 or FC 0595.
To remove the front cover: Pull the top of the cover away from the frame.
To remove the right side cover: Lift up on the latch and slide the cover to the rear of the tower.
To remove the rear cover: Lift the cover to detach.

FC 5095, FC 0595 - Device board - DB1 and DB2

For use by authorized service providers.
Use this procedure to remove or replace the device board - DB1 and DB2 on an FC 5095, FC 0595.
To remove or replace the device board - DB1 and DB2:
1. Power off the expansion unit. See the Expansion unit power procedure.
2. Unplug the power cord from the back of the expansion unit.
3. Remove the front and right side covers. See FC 5095, FC 0595 - Covers.
4. Remove the EMC shield in front of the disk units by pulling out on the two side latches.
5. Remove the disk units from the disk unit cage. Label the position of each disk unit.
6. Remove the screws holding the disk unit cage to the frame. The screws are located on the front and
inside rear of the disk unit cage.
7. Unplug and remove the cables plugged into the back of the device board.
8. Pull the disk unit cage out of the frame.
9. Remove the device board from the back of the disk unit cage.
10. Install the device board by reversing the removal procedure.
This ends the procedure.

FC 5095, FC 0595 - Disk unit (concurrent)

For use by authorized service providers.
Use this procedure to remove or replace a disk unit (concurrently) in an FC 5095, FC 0595.
Attention: If removing the cover while the system is powered on, errors may occur due to electromagnetic
interference.
Attention: The disk unit is sensitive to electrostatic discharge. See Work with electrostatic
discharge-sensitive parts.
To remove or replace a disk unit concurrently:
1. Determine if the system has logical partitions. Go to Determine if the system has logical partitions,
before continuing with this procedure.
2. Were you directed here from Recovery procedures?
v Yes: Continue with the next step.
194
Hardware (Remove and Replace; Part Locations and Listings)