Example For Configuring User Login By Using Stelnet - Huawei AR2200 Series Configuration Manual

Huawei AR2200 Series Enterprise Routers
Configuration Guide - Basic Configuration
<Huawei> system-view
[Huawei] interface gigabitethernet 1/0/0
[Huawei-GigabitEthernet1/0/0] ip address 202.38.160.92 255.255.0.0
[Huawei-GigabitEthernet1/0/0] quit
# Configure the login authentication mode
[Huawei] aaa
[Huawei-aaa] local-user huawei password cipher hello
[Huawei-aaa] local-user huawei service-type telnet
[Huawei-aaa] local-user huawei privilege level 3
[Huawei-aaa] quit
[Huawei] user-interface vty 0 4
[Huawei-ui-vty0-14] authentication-mode aaa
Step 3 Configure the client login.
Run the Telnet on the PC, as shown in
Figure 5-6 Running the Telnet program on the PC
Click OK.
Enter the user name and password in the login window. After authentication, a command line
prompt such as <Huawei> appears. Enter the configuration environment in the user view.
----End

5.6.3 Example for Configuring User Login by Using STelnet

This part provides an example describing how to configure user login by using STelnet.. In this
example, after generating the local key pair on the SSH server, configuring the name and
password of the SSH user on the SSH server, and enabling the STelnet service on the SSH server,
you can connect the Stelnet client to the SSH server.
Networking Requirements
As shown in
client can log in to the SSH server with the password, RSA, password-rsa, or all authentication
mode.
In this configuration example, the password authentication mode is used.
Issue 02 (2011-10-15)
Figure 5-7, after the STelnet service is enabled on the SSH server, the STelnet
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-6.
5 Configuring User Login
80