Setting Physical Attributes Of A Tty User Interface - Huawei AR2200 Series Configuration Manual

Huawei AR2200 Series Enterprise Routers
Configuration Guide - Basic Configuration
Pre-configuration Tasks
Before configuring a TTY user interface, complete the following tasks:
l
Data Preparation
To configure a TTY user interface, you need the following data.
No.
1
2
3

4.4.2 Setting Physical Attributes of a TTY User Interface

You can configure the rate, flow control mode, parity mode, stop bit, and data bit for an
asynchronous serial port.
Context
Physical attributes of an asynchronous serial port have default values on a router and no
additional configuration is needed.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface TTY interface-number
The TTY user interface view is displayed.
Issue 02 (2011-10-15)
Logging in to the router by using a terminal
Data
Baud rate, flow-control mode, parity, stop bit, and data bit
Idle timeout period, number of lines displayed in a terminal screen, and the size of
history command buffer
User priority
NOTE
All the default values (excluding the password and username) are stored on the router and do not need
additional configuration.
NOTE
l If you need to log in to a router through an asynchronous serial port, install an SA or SA board on the
router. If an SA board installed, set the interface working mode to asynchronous mode on the SA board.
l The Hyper Terminal and router must use the same physical attributes, including the baud rate, flow
control mode, parity mode, stop bit, and data bit. If values of any attributes are different, you cannot
log in to the router.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuring User Interface
46