Setting Physical Attributes Of A Tty User Interface - Huawei AR1200 Series User Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Basic Configuration
terminal attributes, and user priority. These parameters have default values that require no
additional configuration , but you may modify these parameters as needed.
Pre-configuration Tasks
Before configuring a TTY user interface, complete the following tasks:
l
Data Preparation
To configure a TTY user interface, you need the following data.
No.
1
2
3

4.4.2 Setting Physical Attributes of a TTY User Interface

You can configure the rate, flow control mode, parity mode, stop bit, and data bit for an
asynchronous serial port.
Context
Physical attributes of an asynchronous serial port have default values on a router and no
additional configuration is needed.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface TTY interface-number
The TTY user interface view is displayed.
Issue 04 (2012-05-15)
Logging in to the router using a terminal
Data
Baud rate, flow-control mode, parity, stop bit, and data bit
Idle timeout period, terminal screen length, and the size of history command buffer
User priority
NOTE
All the default values (excluding the password and username) are stored on the router and do not need
additional configuration.
NOTE
l If you need to use an asynchronous serial port to log in to a router, install an SA board on the router
and set the interface working mode on the board to asynchronous mode.
l The Hyper Terminal and router must have the same physical attributes, including the baud rate, flow
control mode, parity mode, stop bit, and data bit. If values of any attributes are different, you cannot
log in to the router.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuring User Interfaces
59