Powering-On The Cutter; Media Is Loaded And Cutter Is Ready; Cutter Is Ready No Media Is Loaded; Power Entry Module - Summa SUMMACUT User Manual

SummaCut cutter

1.3.3 Powering-on the cutter

CAUTION: Be sure the power switch is turned off before connecting the power cord (the "0"
side of the ON/OFF rocker switch should be pressed).
KEEP FINGERS AND OTHER BODY PARTS AWAY FROM THE CUTTING AREA. THERE
1. Plug the female end of the AC power cord into the receptacle located in the power
entry module on the cutter's rear panel.
2. Plug male end of the AC power cord into a properly grounded wall socket.
3. Power on the cutter by pressing the "I" side of the ON/OFF rocker switch located on the
power entry module on the rear panel.
4. The touch screen will activate and the initialization process will begin. If media is
loaded, then the cutter will check size and load the media.
FIG 1-13
1-13

MEDIA IS LOADED AND CUTTER IS READY

Setup
WARNING
ARE HAZARDOUS MOVING PARTS.
User's Manual
FIG 1-14
1-14

CUTTER IS READY NO MEDIA IS LOADED

1-10