Table of Contents
Advertisement
Wiring and Connections
Connecting an S-Video Input
1. Connect the UDM-SVID01 HD15 to SVideo cable (FG-UDM-SVID01, not included) to the video
source's S-Video connection.
2. Attach the other end of the cable to the appropriate VIDEO IN connection (A or B) on the UDM.
3. Connect any audio to the analog (RCA) audio connectors or digital (SPDIF) connector.
Cascade IN/OUT Ports
The Cascade IN and Cascade Out ports allow UDM Hubs to be chained together to increase the number
of inputs which can be delivered to the end points (FIG. 14). This is known as "cascading" the hubs.
FIG. 14
Cascade IN/OUT Ports
Refer to the Cascading Hubs section on page 79 for details on configuring cascaded Hubs.
IEC Power Connector
The UDM-1604C uses a universal switch-mode power supply, which operates from 90-264V AC,
50/60Hz, with a power consumption of 130W fully loaded.
As a Class 1 appliance the UDM-1604C should be connected to a mains supply with
a protective earthing connection.
Powering the UDM-1604C Hub On
1. Ensure a standard PC mains lead has been connected to the 3-pin power connection, and then
connected to a mains power source.
2. Flip the power switch down to its On (|) position.
Powering the UDM-1604C Hub Off
Where a mains plug (or appliance coupler) is used in the event of a fault, the hub can
be disconnected from the mains by removing the lead from the IEC inlet or from the
mains socket.
It is important that the hub is installed in such a way that this method remains readily
operable.
The user should have easy access to either the IEC inlet or the mains socket in the
event of a fault.
To turn the UDM-1604C off, flip the Power switch to it's Off (0) position.
16
The Cascade In and Cascade Out ports are used to cascade two UDM hubs.
A UDM-EXP-01 cascade cable (optional) is required to connect the UDM hubs together.
The rating label found to the bottom left of the hub, beneath the IEC connector, contains
important information applicable to the Hub's installation environment.
The Power On/Off switch is located beside the IEC power connector.
UDM-1604C 4x16 Multi-Format Distribution Hub
Advertisement
Table of Contents
