Dual Output Mode - AMX UDM-1604C Operation/Reference Manual

Configuration - Status Page
3. The amber LED at the Cat5 port on the UDM-RX02 will start to flash, indicating the UDM-RX02 is
in compensation mode.
4. Use the buttons on the remote control to adjust appropriately the following up or down;
5. Once the image displayed is of an acceptable quality, push the A button on the remote control to exit
compensation mode.
The compensation settings will be specific to this UDM-RX02 and stored internally
(for example, if this UDM-RX02 is replaced or swapped out the compensation
settings will travel with the UDM-RX02). It may therefore be necessary to re-
compensate the UDM-RX02 / replacement UDM-RX02 if this UDM-RX02 is to be
used elsewhere or is being replaced.

Dual Output Mode

With the Enable advanced options checkbox selected in the Setup page (see FIG. 23 on page 30), the
Port Configuration options include the Dual Output checkbox (FIG. 25).
Dual Output mode permits a single input to be viewed as two separate output types. For example a port
could be configured for the dual output of VGA and Component video. This means at the UDM
Receiver, the input could be delivered to two separate display devices.
.
Ensure the correct cabling is in place at the RX to accommodate the 2 separate
signals.
32
Sharpness
Gain
Red, Green and Blue.
UDM-1604C 4x16 Multi-Format Distribution Hub