Table of Contents
Advertisement
Configuration
WebConsole Overview
Each UDM-1604C Hub can be configured for the correct network environment. It is also possible to
configure each Hub for the correct date and time. Configuration options are available via the UDM's
built-in WebConsole, as described in this section.
The UDM-RX02 Receiver connected to the UDM-1604C is also configured via the 1604's WebConsole.
This section describes the pages that comprise the UDM-1604C's WebConsole
interface in the order that they are presented ("Status", "Setup", "Inputs", "Devices"
"Schedule" and "Protocols"). However, on initial connection, you'll probably need to
visit the Setup page first, to specify network configuration and other basic device
setup options for the Hub.
See the Configuration - Setup Page section on page 45 for details.
Connecting to the UDM-1604C
Use the included Ethernet Crossover cable for initial setup.
1. The default IP address of the UDM-1604C is 192.168.0.96.
2. Enter the IP address into the address field within a browser window.
3. To connect to the UDM-1604C, a password is required.
4. On initial connection, the Status page is displayed (FIG. 19) .
FIG. 19
Status page (Initial View)
UDM-1604C 4x16 Multi-Format Distribution Hub
The username should be left blank.
The password is admin (case-sensitive).
Click links to access the six main
areas of the WebConsole
(initial view is Status)
Configuration
25
Advertisement
Table of Contents
