Issuing Commands To A Selected Port - AMX UDM-1604C Operation/Reference Manual

Issuing Commands To a Selected Port

Ensure the device's IR commands have been learned by the Hub first. Refer to the
Configuration - Protocols Page section on page 71.
Control of the input is performed in a similar way to changing the input to be displayed. Commands can
either be issued per Input or issued across all or groups of ports.
1. For the Port that you want to issue a command, open the Control drop-down menu, as shown in
FIG. 33.
FIG. 33 Control drop-down menu
2. Select the required command from the Control drop-down menu.
Where a custom control is required, type in the IR code for the command. Refer to
the Creating and Learning an IR Protocol section on page 74.
3. Once selected, click on Execute (see FIG. 33) to execute the selected command for the relevant
port.
Ensure that an (optional) IR01 Endeleo IR Emitter Module (FG-IR01) is connected to
the Receiver's IRTX port. Attach it to the Device's IR sensor before issuing a
command. The IR Emitter transmits the command from the Receiver directly to the
device's IR sensor.
UDM-1604C 4x16 Multi-Format Distribution Hub
Click to execute the selected
Command on this Port
Control drop-down menu
Configuration - Status Page
37