Table of Contents
Advertisement
Advanced Administration
The table below describes typical values returned when using the ? command on an input port.
Multi-Format Input Configuration
Value
129
00.06.00
XGA
1024x768
799
H+
V+
User Outputs
1. To view a port's properties, type a question mark before the port number.
Ensure there is a space between the question mark and the number. (FIG. 126)
For example ? 1 will display Port 1 properties.
FIG. 126
Querying a port
2. Push Enter once the command has been entered.
3. The table below describes typical values returned when using the ? command on a Hub port.
Value
Port 1
01.11.00
Clock Master 8406
Disconnected / Connected Connected to RX
Port Power
Port Number Checksum
Copying IR/Serial Tables
To copy the IR/Serial tables from a UDM Hub:
Windows XP Pro has a built in TFTP client program. If you are using another
operating system, or have an alternate TFTP client, follow the directions of your OS
and install TFTP client if necessary. Consult with AMX Technical Support as to the
appropriate client for your OS.
1. Run your TFTP client. If using the Windows client, move to step 2.
2. Create a folder on the C: drive named Endeleo.
3. Open a command prompt (Start, Run, type "cmd" <enter>) and change it to the C:\Endeleo
directory.
4. Connect the serial cable (RJ12 to DB9) that is supplied with the UDM Hub.
100
Description
Input A
Input Controller Version
Extended Graphics Array
Screen Resolution
Vertical lines on screen
Horizontal polarity (+/-)
Vertical polarity (+/-)
Description
Port number on UDM Hub
Port Controller version
Master (version)
On or Off
Port in Master or Target Hub
UDM-1604C 4x16 Multi-Format Distribution Hub
Advertisement
Table of Contents
