Disengaging Track Waypoint Mode; Turn Buttons Or Joystick In Track Waypoint Mode; Auto Heading Button In Track Waypoint Mode; Acknowledging A Turn During A Waypoint Arrival - Mercury MerCruiser Axius 350 MAG User Manual

Section 3 - On The Water
NOTE: This display screen is activated during VesselView calibration. The GPS system generates the displayed heading
based on magnetic North.

Disengaging Track Waypoint Mode

1. Disengage the Track Waypoint mode by one of the following methods:
• Press the "TRACK WAYPOINT" button on the Axius Premier Trackpad. The "TRACK WAYPOINT" button light goes off
and Axius Premier goes to Standby. The "STANDBY" light turns on
• Turn the steering wheel hard enough to overcome the detent and Axius Premier features go into Standby.
• Move both ERC levers back to neutral and Axius Premier goes to Standby.
• Press either "TURN" button and Axius Premier goes to Auto Heading mode.
• Press the "AUTO HEADING" button and Axius Premier CAN Trackpad goes to Auto Heading mode.
• Turn off the chart plotter and Axius Premier goes to Standby.
2. You can resume the Track Waypoint heading within one minute, if the vessel has not turned too far and the "RESUME" light
is still on or flashing.

Turn Buttons or Joystick in Track Waypoint Mode

While in "TRACK WAYPOINT" mode, press the left or right "TURN" buttons on the Trackpad or use the joystick to change the
mode to "AUTO HEADING."

Auto Heading Button in Track Waypoint Mode

While in "TRACK WAYPOINT" mode, press the "AUTO HEADING" button to cause Axius Premier to change to "AUTO HEADING"
mode.

Acknowledging a Turn During a Waypoint Arrival

IMPORTANT: Track Waypoint mode does not automatically turn the boat upon arrival at a plotted waypoint.
Page 70
Track Waypoint screen
31413
90-864197084 NOVEMBER 2008