Table of Contents
Advertisement
Disengage Auto Heading
1.
Disengage the Auto Heading mode by any of the following actions:
•
Place the ERC levers for both engines in neutral.
•
Turn the steering wheel beyond the electronic detent.
•
Press the "AUTO HEADING" button on the Axius track pad. The "AUTO HEADING" button LED light turns off.
STANDBY
TURN
RESUME
a
b
AUTO
HEADING
To Resume to a Heading
The "RESUME" button light turns on if the previous course heading is available to resume. The previous heading can only be
resumed within one minute of the Auto Heading being disengaged or if the boat has not turned more than 90°. You can adjust
these values during configuration.
If you disengage the Auto Heading by turning the steering wheel or if you press one of the "TURN" buttons with Auto Heading still
engaged, press the "RESUME" button to resume the previous heading.
Changing VesselView Mode Display Times
All modes display a screen on VesselView for three seconds by default. The length of time that a screen is visible in VesselView
can be changed from no display at all, display up to 10 seconds, or display the screen until changed.
To change the display time:
1.
Open VesselView.
2.
Select Setting.
3.
Select Screen Options.
4.
Select the mode you want to change.
5.
Select the option you desire.
6.
Press × to exit.
Cruise Control
The VesselView system features integrated throttle cruise control (cruise), which allows the operator to limit the peak RPM of
choice below Wide Open Throttle (WOT). This feature requires VesselView. Refer to the owner's manual provided with your
VesselView for operation instructions.
These additional notes are exclusive to your package:
•
You can change or disengage cruise through the screen at any time.
•
Cruise resets when the key is turned off.
•
If the cruise limit is changed while the levers are at WOT, cruise gradually changes to the new speed.
•
Cruise does not disengage if the ERC levers are at a higher engine speed than the actual RPM. Bring the levers back to the
forward detent to disengage.
After Break‑In Period
To help extend the life of your Mercury MerCruiser power package:
•
Ensure the propeller allows the engine to operate at or near the top of the specified WOT RPM range (Refer to
Specifications and Maintenance) when at full throttle with a normal boat load.
•
Operate at 3/4 throttle setting or lower. Refrain from prolonged operation at WOT RPM.
•
Change the engine oil and oil filter. Refer to Maintenance.
90-864197084 NOVEMBER 2008
a -
Button LED light
b -
"AUTO HEADING" button
ACTIVE
TURN
32510
Section 3 - On The Water
Page 55
Advertisement
Table of Contents
Troubleshooting
