Serpentine Drive Belt; Checking - Mercury MerCruiser Axius 350 MAG User Manual

8. Install the propeller shaft anode over the propeller shaft nut.
9. Place the flat washer onto the propeller shaft anode screw.
10. Place the star washer onto the propeller shaft anode screw.
11. If a propeller shaft anode is reinstalled, apply Loctite Threadlocker 271 to the threads of the propeller shaft anode screw.
b
c
d
f
e
Tube Ref No.
Loctite 271 Threadlocker
7
12. Secure the propeller shaft anode to the propeller shaft using the propeller shaft anode screw and washers. Torque the screw.
Description
Propeller shaft anode screw 38 mm (0.3125‑18 x 1.5 in.) long

Serpentine Drive Belt

Checking

Inspecting the belts with the engine running may cause serious injury or death. Turn off the engine and remove the ignition key
before adjusting tension or inspecting belts.
a
h
g
1. Inspect the serpentine drive belt for the following:
• Excessive wear
• Cracks
90-864197084 NOVEMBER 2008
Description
c
b
f
a - Propeller
b - Propeller shaft nut
c - Propeller shaft anode
d - Propeller shaft anode screw
e - Flat washer
f - Star washer
a
5303
Where Used
Propeller shaft threads
WARNING
!
a - Alternator pulley
b - Water circulating pump pulley
d
c - Tensioner pulley and adjustment stud
d - Serpentine belt
e - Steering pump pulley
f - Crankshaft pulley
e
g - Seawater pump pulley
h - Idler pulley
33283
Section 5 - Maintenance
Part No.
92-809819
Nm llb‑in.
27 –
Page 103
lb‑ft
20