Throttle Only; Single) Lever - Mercury MerCruiser Axius 350 MAG User Manual

With emissions control
Table of Contents

Advertisement

Section 3 - On The Water

Throttle Only

To engage Throttle Only mode:
1.
Place both ERC levers in neutral.
2.
Press the "THROTTLE ONLY" button, located on the DTS trackpad.
3.
The "THROTTLE ONLY" button light illuminates and the neutral lights blink.
4.
Place either ERC lever into gear.
5.
The RPM of the engines can be increased, while the transmissions remains in Neutral.
NOTE: Pressing the "THROTTLE ONLY" button while the ERC levers are in gear, turns off the button light, but the boat remains
in throttle only mode until you place the levers in neutral.
To disengage throttle only mode:
1.
Bring both ERC levers to neutral. Throttle only will not disengage unless the ERC levers are in neutral.
2.
Press the "THROTTLE ONLY" button. The "THROTTLE ONLY" button light turns off.
3.
The neutral lights remains on.

1 (Single) Lever

The Axius system features the ability to command both engines with a single lever. This feature simplifies engine management
during rough sea conditions by allowing you to grasp a single lever to command both engines simultaneously.
To engage 1 (single) lever mode:
1.
Place both ERC levers in neutral.
2.
Press the "1 LEVER" button located on the DTS Trackpad attached to the ERC levers.
Page 50
"THROTTLE ONLY" button
"1 LEVER" button
31465
31466
90-864197084 NOVEMBER 2008

Advertisement

Table of Contents
loading

Table of Contents