Table of Contents
Advertisement
3.
The "1 LEVER" button lights.
4.
Place the starboard ERC lever into gear.
5.
The engine RPM raises and lowers simultaneously while the transmissions remain in the same gear.
To disengage 1 (single) lever mode:
1.
Place both ERC levers in neutral.
2.
Press the "1 LEVER" button. The "1 LEVER" button light turns off.
Sync
The Axius system features Sync, an automatic engine synchronization feature, which engages automatically at key‑up. Sync
monitors the position of both levers. If both levers are within 10% of one another, the port engine synchronizes to the starboard
engine's RPM. The smartcraft system will automatically disengage Sync at the last 10% of lever range to allow each engine the
ability to reach maximum available RPM. Sync cannot engage until its minimum RPM is met.
VesselView shows an orange icon if the engines exceed a 10% difference in RPM of each other, and the icon turns red when they
synchronize. The icon turns off when Sync is off.
To disengage Sync mode:
1.
Place the ERC levers in any detent.
2.
Press the "SYNC" button.
To re‑engage Sync mode, press the "SYNC" button.
Axius Plus CAN Control Pad (If Equipped)
General Information
•
Axius Plus CAN Control Pad functions are controlled through the Axius trackpad only.
•
Axius Plus CAN Control Pad screens, when accessed by the trackpad, appear on the VesselView for three seconds unless
calibrated otherwise.
•
Pressing any button on VesselView dismisses the Axius Plus CAN Control Pad screen from the VesselView screen, unless
the screen was chosen from the VesselView environment menu.
NOTE: Not all of the functions of the Axius system work when DTS functions are engaged. Disengage the DTS functions to use
the functions of Axius track pad.
The following information shows the location and explains the function of the Axius track pad lights and buttons.
Heading Adjustment and Override
When Auto Heading is engaged, the steering wheel feels locked into a detent . Approximately 3.4–4.5 kg (8–10 lb.) of force are
required to overcome this detent. Manually overcoming the steering wheel's detent force automatically puts Axius CAN into standby
mode.
1.
When Auto Heading is engaged the "TURN" buttons provide a 10° course correction for each press to the port or starboard.
2.
The joystick provides a 1° course correction for each press to the port or starboard.
90-864197084 NOVEMBER 2008
31467
"SYNC" button
Section 3 - On The Water
Page 51
Advertisement
Table of Contents
Troubleshooting
