Table of Contents
Advertisement
9.
Remove the filter cup from the filter cap by grasping the filter cap and rotating it in a clockwise direction while holding the filter
cup stationary.
10. Remove the used water‑separating fuel filter element from the filter cup, place it in a clean, approved container.
11. Dispose of any water or debris that may be in the filter cup.
Installation
1.
Install a new water‑separating fuel filter element into the filter cup. Push the element into the cup until completely seated.
2.
Install new O‑ring on the filter cup.
3.
Attach the filter cap to the filter cup by grasping the filter cap and rotating it in a counter clockwise direction while holding the
filter cup stationary, until the filter cap locks securely into place.
4.
Install the fuel filter assembly slowly into the Cool Fuel Module to prevent spilling fuel, and align the screws retained in the
filter cap with the screw holes in the Cool Fuel Module. Tighten the filter assembly retaining screws until hand tight.
5.
Ensure that the filter cap is firmly seated against the Cool Fuel Module and torque each filter assembly retaining screw.
Description
Filter assembly retaining screw
6.
Open fuel supply valve, if equipped.
7.
Reconnect the Cool Fuel Module harness to the engine wiring harness.
8.
Properly ventilate the engine compartment.
Without sufficient cooling water, the engine, the water pump, and other components will overheat and suffer damage. Provide
a sufficient supply of water to the water inlets during operation.
9.
Supply cooling water to the engine.
10. Start the engine. Check for gasoline leaks around the fuel filter assembly. If leaks exist, stop the engine immediately. Recheck
the filter installation, clean spilled fuel and properly ventilate the engine compartment. If leaks continue, stop engine
immediately and contact your authorized Mercury MerCruiser dealer.
Lubrication
Electronic Shift Control (ESC) Shift Cable
1.
Lubricate the pivot points and the guide contact surfaces.
d
c
b
Tube Ref. No.
90-864197084 NOVEMBER 2008
a
32233
Description
Synthetic Blend MerCruiser Engine Oil
SAE25W‑40
NOTICE
a -
Pivot points
b -
Shift actuator
c -
Guide contact surfaces
d -
Shift cable
Shift cable pivot points &
guide contact surfaces
Section 5 - Maintenance
Nm
lb. in.
6
53
Where Used
92‑883725K01
lb. ft.
Part No.
Page 99
Advertisement
Table of Contents
Troubleshooting
