Table of Contents
Advertisement
Date
Maintenance Performed
Engine Oil
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law. Use caution not to spill oil, coolant,
or other fluids into the environment when using or servicing your boat. Be aware of the local restrictions governing the disposal
or recycling of waste, and contain and dispose of fluids as required.
Checking
1.
Stop the engine. Allow approximately 5 minutes for the oil to drain into the oil pan. The boat must be at rest in the water.
2.
Remove the dipstick. Wipe clean and reinstall fully into the dipstick tube. Wait 60 seconds to allow trapped air to vent.
NOTE: Ensure that dipstick is installed with oil level indication marks facing the rear of the engine (flywheel end).
IMPORTANT: Add the specified engine oil to bring the level up to, but not over, the full or OK range mark on the dipstick.
3.
Remove the dipstick and observe the oil level. Oil level must be between full or OK range and add. Reinstall dipstick into
dipstick tube.
Filling
IMPORTANT: Do not overfill the engine with oil.
IMPORTANT: Always use the dipstick to determine the exact quantity of oil or fluid required.
90-864197084 NOVEMBER 2008
NOTICE
a -
Dipstick tube
a
6095
Section 5 - Maintenance
Engine Hours
Page 87
Advertisement
Table of Contents
Troubleshooting
