Table of Contents
Advertisement
Section 3 - On The Water
7.
If the ERC handles are moved to neutral, Auto Heading turns off, a single beep sounds, and the "STANDBY" light turns on.
You cannot resume your course by pressing the "RESUME" button.
Pressing the "AUTO HEADING" button causes VesselView to displays the "AUTO HEADING" screen for three seconds. If the
VesselView "AUTO HEADING" screen does not appear, the "AUTO HEADING" screen needs to be activated in VesselView
calibration. Axius still engages whether the screen appears or not.
NOTE: If you press the "AUTO HEADING" button a second time, the Axius goes to standby mode and all lights other than
"STANDBY" turn off.
Disengage Auto Heading
1.
Disengage the "AUTO HEADING" mode by any of the following actions:
•
Place the ERC levers for both engines in neutral.
•
Turn the steering wheel beyond the detent.
•
Press the "AUTO HEADING" button on the Axius touchpad. The "AUTO HEADING" button LED light turns off.
a -
Indicator light
b -
"AUTO HEADING" button
To Resume to a Heading
The "RESUME" button light turns on if the previous course heading is available to resume. The previous heading can only be
resumed within one minute of the Auto Heading being disengaged or if the boat has not turned more than 90°. You can adjust
these values during configuration.
If you disengage the Auto Heading by turning the steering wheel or if you press one of the "TURN" buttons with Auto Heading still
engaged, press the "RESUME" button to resume the previous heading.
Page 60
b
c
31408
a
b
a -
"OFF" button
a
b -
Current heading
c -
Drive positions
d -
Engine RPM
d
35561
90-864197084 NOVEMBER 2008
Advertisement
Table of Contents
Troubleshooting
