Status:operation:enable; Status:operation[:Event]; Status:preset - HP E1418A User Manual

STATus:OPERation:ENABle?

Parameters

STATus:OPERation[:EVENt]?

Parameters
Comments

STATus:PRESet

Chapter 3
STATus:OPERation:ENABle?
Status Register.
Returns: 16-bit signed integer (int16).
STATus:OPERation[:EVENt]?
Status Event Register. Reading the register clears all bits in the register.
Returns: 16-bit signed integer (int16).
•
Bit 0 of this register (decimal 1) is the only defined bit in this register.
•
This bit is set if the CALibration:CONFigure:RESistance?
n
CALibration :CONFigure:VOLTage?
command has been received and the calibration process is not yet complete.
•
*RST Condition: no effect.
• *CLS
clears the contents of the Operation Status Register.
• STATus:PRESet
does not affect the contents of the Operation Status Register, but
does disable reporting the Summary bit to the Status Byte Register.
presets all Enable Registers to 0 (zero). The command has no
STATus:PRESet
effect on Condition or Event Registers.
returns the value of the mask set for the Operation
returns the value of the contents of the Operation
, or n
CALibration
HP E1418A SCPI Command Reference
STATus
,
:CONFigure:CURRent?
96