Sourcen:function:mode - HP E1418A User Manual

SOURce n :FUNCtion:MODE
Parameters
Comments
Chapter 3
n
SOURce :FUNCtion:MODE <
voltage output.
Parameter Parameter
Name
n keyword
SOURce
mode discrete
< >
•
In the keyword, SOURce
1 to 8 for E1418A, E1418A Option 002
1 to 16 for E1418A Option 001, E1418A Option 003.
Values of n outside these ranges will generate an error.
•
Following this command, the output is disabled and set to either 0 A or 0 V.
•
If the module is in the wait-for-trigger state when this command is received, an
error is generated.
•
This command is affected by the state of the P/J jumper for this channel on the
terminal module. If the P/J jumper is not set to program selectable this command
will return an error. This jumper is described on page 31.
•
*RST Condition:
If the P/J jumper is set to program selectable:
–
output mode is set to voltage, 0 volts output, output relay open.
If the P/J jumper is set to jumper selectable:
–
output mode is set by the V/I jumper, 0 volts or amps, output relay open.
•
Related Commands:
commands, SOURce n
mode configures channel n for either current or
>
Type
CURRent or VOLTage
n, the valid range of n is:
n
SOURce :FUNCtion:MODE?
:VOLTage... commands
HP E1418A SCPI Command Reference
SOURce
Range of
Values
1 to 8 or 1 to 16
, n
SOURce :CURRent...
Default
1
none
88