Sourcen:current[:Level]:Triggered[:Amplitude] - HP E1418A User Manual

SOURce n :CURRent[:LEVel]:TRIGgered[:AMPLitude]
Parameters
Comments
Chapter 3
n
SOURce :CURRent[:LEVel]:TRIGgered[:AMPLitude] <
outputs the current set in value at channel n when the trigger conditions are satisfied and
the output relay is closed. Use this command to synchronize multiple channel outputs.
Parameter Parameter
Name
keyword
SOURce n
numeric (float 32) or
< value >
discrete
•
In the keyword,
SOURce
1 to 8 for E1418A, E1418A Option 002
1 to 16 for E1418A Option 001, E1418A Option 003.
Values of n outside these ranges will generate an error.
•
The < value > parameter is a floating point 32-bit number in the range of -0.02 A
to +0.02 A.
sets -0.02 Amps.
MIN
sets +0.02 Amps.
MAX
DEF sets 0 Amps.
•
This command sets channel n to output the current specified following a valid
trigger condition. Following this command, the trigger system must be enabled
using an INITiate command. See the
for additional information.
•
If the module is in a wait-for-trigger state (
command is received, an error is generated.
•
The output state of the channel must be enabled and the trigger event satisfied for
the current to appear at the output terminals.
•
If the channel is in the voltage mode when this command is received, an error is
generated.
•
Related Commands:
SOURce n :FUNCtion:MODE CURRent
Type
-0.02 Amps to +0.02 Amps or
MIN | MAX | DEF
n, the valid range of n is:
TRIGger subsystem discussion on page 54
INIT
n
SOURce :CURRent[:LEVel]:TRIGgered[:AMPLitude]?
, OUTPut
HP E1418A SCPI Command Reference
SOURce
value
| MIN | MAX | DEF>
Range of
Values
1 to 8 or 1 to 16
has been received) when this
n [:STATe]
Default
1
0
,
86