Applyn:voltage - HP E1418A User Manual

APPLy n :VOLTage
Parameters
Comments
Chapter 3
n value
APPLy :VOLTage <
channel, n.
Parameter Parameter
Name
n keyword
APPLy
value numeric (float 32) or
< >
discrete
•
In the keyword,
APPLy
1 to 8 for E1418A, E1418A Option 002
1 to 16 for E1418A Option 001, E1418A Option 003.
Values of n outside these ranges will generate an error.
•
The value parameter can range from -16 Volts to +16 Volts.
< >
MIN sets -16 Volts output.
sets +16 Volts output.
MAX
sets 0 Volts output.
DEF
•
This command is affected by the state of the program jumper on the terminal
module for this channel. To use the
the P/J jumper must be set to program selectable or, if set to jumper selectable,
–
the V/I jumper must be set to the voltage mode.
–
This jumper is described on page 31.
•
Equivalent Commands:
n
SOURce :VOLTage[:LEVel][:IMMediate][:AMPLitude]
•
*RST Condition:
If the P/J jumper is set to program selectable:
–
output mode is set to voltage, 0 volts output, output relay open.
If the P/J jumper is set to jumper selectable:
–
output mode is set by the V/I jumper, 0 volts or amps, output relay open.
| MIN | MAX | DEF>
Type
-16 V to +16 V or MIN | MAX | DEF
n, the valid range of n is:
APPLy n :VOLT
SOURce n :FUNCtion:MODE VOLT
HP E1418A SCPI Command Reference
outputs a voltage on the specified
Range of
Values
1 to 8 or 1 to 16
command:
,
, n
OUTPut [:STATe] ON
APPLy
Default
1
0
64