Ieee-488.2 Common Command Quick Reference - HP E1418A User Manual

IEEE-488.2 Common Command Quick Reference

Note
Command
*CLS Clear status registers
Event status enable
*ESE < mask >
*ESE? Event status enable query
*ESR? Event status register query
*IDN? Identification query
*OPC Operation complete
*OPC? Operation complete query
*RST Reset
Service request enable
*SRE < mask >
*SRE? Service request enable query Queries the Service Request Enable Register.
*STB? Read status byte query
*TST? Self-test query
*WAI Wait to continue
*TRG Trigger
*DMC Define macro
*GMC? Menu query
*PMC Purge macros
*LMC? List macros
n Enable macro
*EMC < >
Enable macro query
n
*EMC? < >
*RMC Remove macros
Chapter 3
IEEE-488.2 Common Command Quick Reference
The following table lists the IEEE-488.2 Common (*) Commands that can be executed
by the HP E1418A D/A module. For more information about Common Commands,
consult ANSI/IEEE Standard 488.2-1987.
These commands apply to many instruments and are not documented in detail here.
Title
Clears the event registers and request for OPC flag.
Sets bits in the Event Status Enable Register.
Queries the Event Status Enable Register.
Queries and clears the contents of the Standard Event Status Register.
Returns the identification string of the module.
Sets the Request for OPC flag when all pending operations have been
completed. Also sets the OPC bit in the Standard Event Register.
Returns a 1 to the output queue when all pending operations are complete.
Disables all outputs. Rewrites calibration data from FLASH to RAM. Sets all
outputs to 0. Sets, if not jumpered, all outputs to voltage mode. Enables
trigger with source IMM.
Sets the Service Request Enable bits and corresponding Serial Poll Status
Byte Register bits to generate a service request.
Queries the Status Byte Register.
Performs the internal self-test. Disables all outputs. Sets all outputs to 0.
Returns the first error found in a 16-bit integer. See page 102.
Waits until all relays are settled and the idle trigger state is reached.
Causes an immediate trigger.
Defines a macro.
Gets the results of a menu query.
Purges all macros from memory.
Lists macros by name.
Enables execution of macro
Queries execution state of macro
Removes all macros.
Description
n
.
n
.
HP E1418A SCPI Command Reference 106