Accu-Chek Mobile User Manual page 75

Connecting the meter to the PC
1
Plug the Micro B connector of the
USB cable into the USB port on
your meter.
Connect the other end of the USB
cable to your PC.
i
• If you disconnect the cable between meter and PC, the meter turns off.
• Remove the USB cable after analysing the test results on the PC so that the meter battery power is
not consumed unnecessarily.
• You cannot perform a test while the meter is connected to the PC.
Analysing test results on the PC
2a and 2b
2a – With the meter off:
The meter turns on. Depending
on the selected default (see
Defining the default page 71),
the analysis of the test results is
started with Data transfer or
Reports.
2b – With the meter on:
The meter opens the PC analysis
menu. Other running operations
are aborted.
2c
If you connect the meter to a PC
while a test is in progress, the
test is cancelled and a message
appears on the screen.
Press .
The meter starts data analysis
via Data transfer or Reports,
depending on the default.
7
73