Nortel Modular ICS 4.0 Manual page 217

Not in service
Parked call
Pick up receiver
Priority> 221
BLOCK
Release a call
Use line pool?
YES NO
Hold or release
Release calls
P0881591 Issue 01
The telephone to which you directed a call is
not in service or is otherwise unavailable.
The call is returned to your telephone.
No one answered the call you parked. The
CALLBACK
call has come back to you.
You have used the Call Queuing feature
without picking up the receiver. Auto
Handsfree has not been assigned to your
©
telephone. You must use the receiver or
You are receiving a priority call. If you are on
another call, inform the person you are
speaking to that you are about to put the call
on hold. Press the flashing line indicator of
the priority call or wait until the call connects
automatically (in eight seconds). The priority
call goes through when you hear the next
beep. Your active call is placed on Exclusive
Hold. It is reconnected automatically when
the priority call ends (unless you transfer the
priority call, in which case you must press the
line button of your original call to reconnect).
Use DND (
to reject a priority call.
You have no free line buttons on which to
receive a call. Release one of your current
calls and try again to answer the incoming
call.
You have received a Ring Again offer for a
line pool. Press the flashing internal line
button or YES to use the line pool. On the
M7100 telephone, just lift the receiver.
Otherwise, press NO or wait 30 seconds for
the Ring Again offer to expire.
You cannot program a feature button while
you are on a call.
You have tried to use a feature while you
were on a call or had calls on hold. Release
the call or calls, before using the feature.
Common feature displays / 205
to answer a call.
ƒ°fi
) or press BLOCK
Modular ICS 4.0 System Coordinator Guide