Nortel Modular ICS 4.0 Manual page 149

Norstar set can be in more than one Hunt Group but is
considered a member in each Hunt Group, increasing the total
number of members in the system.
There can be only one appearance of the same Hunt Group on
a set. Hunt Group DNs cannot be members of other Hunt
Groups. A DN can be associated with a member of a Hunt
Group and is called a member DN.
Consult your customer service representative to determine
your Hunt Group number range.
1. Place the programming overlay on any M7310 or M7324
ƒ••¤flfl‹››
telephone.
2. Press
‡¤‡fi°‡
The display shows Password:.
3. Press
'
Terminals&Sets.
4. Press
≠
prgrming.
≠
5. Press
6. Press
≠
7. Enter the Hunt Group number you want to program (1-30).
8. Press
≠
are no member DNs if none are programmed.)
9. Press
group.
10. Press ADD to add a member or press REMOVE to remove a
®
member from the group.
11. Press
P0881591 Issue 01
until the display shows System
. The display shows Hunt groups.
. The display shows Show group.
. The display shows Member DNs:. (There
. The display shows the members for that
'
to exit or
Programming Hunt Groups / 137
(SCPLUS). The display shows
to continue programming.
Modular ICS 4.0 System Coordinator Guide
(CONFIG).