Using A Line Pool To Make A Call; Programming A Memory Button With A Line Pool Feature Code - Nortel Modular ICS 4.0 Manual

Modular system coordinator guide
Table of Contents

Advertisement

56 / Making calls
The Norstar Modular ICS system can have 15 line pools, and
a telephone can be programmed to access any number of them.
A line pool access code is a number you dial to get a line pool.
The access code can be up to four digits long. You can have
several different line pools for your system, each one giving
you access to a different set of external lines. It is one way of
sharing lines across telephones in a system.
Your installer or customer service representative programs the
line pool access codes and gives each telephone access to a
line pool.
Everyone in the office should have a list of the line pool access
codes for the line pools their telephones can use.

Using a line pool to make a call

ƒfl›
1. Press
2. Enter a line pool access code.
If you have a free internal line, you can make a call using a line
pool without entering the feature code first.
1. Select an internal line (intercom).
2. Dial the line pool access code.
Tip -
Ring Again at the busy tone. You are notified when a line
in the line pool becomes available. See "Using Ring
Again" on page 60.

Programming a memory button with a line pool feature code

When you program a button with the line pool feature code,
you must enter a line pool access code after the feature code.
Modular ICS 4.0 System Coordinator Guide
.
If no lines are available in the line pool, you can use
ƒfl›
P0881591 Issue 01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ics 4.0

Table of Contents