Procedure - Nortel Passport 4400 Using Manual

If you are running Windows 95, Windows 98, or Windows Me, the
Install Tool installation procedure installs Dial-Up Networking for you (if it is
not already present). If you are running Windows NT or Windows 2000, you
must manually install it.
• If you are using a PPP connection, you may need to add a route to access the
Passport network. Refer to

Procedure

To establish a Telnet connection to a remote Passport 4400 device, follow these
steps:
1 Open the Dial-Up Networking window and double-click on the icon for the
connection that you previously defined.
2
Select Telnet from the Install Tool System menu.
The Telnet window opens.
3
Select Connect, then select Remote System.
The Connect dialog box opens.
4 Enter the Host IP address (the IP address of the remote Passport 4400).
5 Click on Connect.
6 Login to the CLI facility:
a
Type
"Defining a Route" on page 91
at the Login prompt, then press Enter.
cli
Using Passport 4400 Install Tool Version 4.2
97
for instructions.