Husqvarna TE 630 2011 I.E. Manual page 82

THROTTLE CABLE ADJUSTMENT
To check the correct adjustment of the throttle cable, op-
erate as follows:
- close tap (1) and tap (2) on the tank;
- disconnect tube (3) from the tank;
- loosen screw (4) and remove the tank;
- loosen screw (5) and remove the protection cover
(6);
- turn throttle twistgrip (7) and make sure it has about
0.08 in. free play;
- if it is not so, loosen the lock nuts (8) and suitably
turn the adjuster screws (9) (loosen to decrease play
or tighten to increase it);
- tighten back the lock nuts (8);
- reassemble all parts, in the reverse order compared
to disassembly.
EN - 24
WARNING*: Operation with damaged
throttle cable could result in an unsafe
riding condition.
WARNING*: Exhaust gas contains poi-
sonous carbon monoxide. Never run the
engine indoors.
4
1
8
2
3
7
5
6
9
8