Husqvarna TE 630 2011 I.E. Manual page 81

COOLANT REPLACEMENT
WARNING*: Coolant shall be replaced
with cold engine and coolant.
Standard procedure
- Place a vessel on the R.H. side of the cylinder, under
the coolant drain screw (1). FIRST remove the screw
(1) then SLOWLY open the R.H. radiator cap (2); slope
the motorcycle on the right side to drain the coolant
easily in the vessel. Reassemble the screw (1).
Fast procedure
- Place a vessel on the R.H. side of the cylinder, under
the tube (3).
- Loosen clamp (4) and disconnect tube (3) from the
engine.
- SLOWLY open the R.H. radiator cap (2); slope the mo-
torcycle on the right side to drain the coolant easily
in the vessel.
- Reassemble the tube (3) and tighten the clamp (4).
1
Standard procedure
- Pour the necessary quantity of coolant in the radiator
then warm up the engine in order to eliminate any
possible air bubbles.
- Allow the coolant to cool down then remove cap (2)
and check the level as explained under "Coolant level
check".
- Periodically check the connecting hoses (see "Sched-
uled Maintenance Chart"): this will avoid coolant
leakage and consequent engine seizure: If hoses (A)
show cracks, swelling or hardening due to sheaths
desiccation, their replacement shall be advisable.
- Check the correct tightening of the clamps (B).
2
A
B
3
4
A
B
B
EN - 23