Husqvarna TE 630 2011 I.E. Manual page 69

1- SPEED (kmh or mph) / ODO / RPM
(figure 1)
- SPEED: vehicle speed - maximum value: 299 kmh or
299 mph;
- ODO: odometer- maximum value: 99999 km;
- RPM: engine r.p.m. shown on the vertical bar indica-
tor.
To replace kilometres with miles or miles with kilometres
proceed as follows:
1) set to figure 1, place the ignition key in the OFF posi-
tion and push the knob SCROLL (A);
2) place the ignition key in the ON position while press-
ing the SCROLL wheel for 3 seconds (A)
To confirm the conversion, the "SET" and the Miles and
mph or km and kmh segment will activate for 3 seconds;
afterwards the standard function in Fig.1 will reappear.
Note*:
After the previously described operation, the ODO setting
will be converted and all other data reset (the H Counter
is unchanged).
2- SPEED / H / RPM (figure 2)
- SPEED: speed - maximum value: 299 kmh or 299
mph;
- H: shows the running hours of the engine (data are
saved in permanent memory every 10 minutes).
- Maximum value: 9999:59;
- RPM: engine r.p.m. shown on the vertical bar indica-
tor.
3- SPEED / CLOCK / RPM (figure 3)
- SPEED: speed - maximum value: 299 kmh or 299
mph;
- CLOCK: Clock- reading from 0:00 to 23:59:59 (the
data will be lost after detaching battery);
To set clock, press the SCROLL button (A) for 3 seconds
or more to increase the hour; release button and after 3
seconds the minutes can be increased;
- RPM: engine r.p.m. shown on the vertical bar indica-
tor.
EN - 11