Firmware Upgrade; Preparations For Firmware Rewriting; Service Environment; Writing Into The Compact Flash - Konica Minolta bizhub 200 Service Manual

Field Service Ver. 2.5 Jul. 2006
5.

Firmware upgrade

5.1

Preparations for Firmware rewriting

5.1.1

Service environment

• Drive which enables writing/reading of Compact flash
• Compact flash (with 32 MB or more)
NOTE
• Make sure that the file system on the compact flash is "FAT".
2
5.1.2

Writing into the Compact flash

• Copy the firmware files using the computer.
NOTE
• The copying operation should be performed on the files contained in the folder,
instead of the folder.
• Copy only those files to be upgraded to the compact flash.
• If wrong firmware is copied, no control panel display is given and thus no firmware
can be downloaded.
5.1.3

Checking ROM version

• Before attempting to upgrade the firmware, check the current ROM version.
See P.201
5.2

Firmware rewriting

NOTE
• NEVER attempt to remove or insert the compact flash with the machine power
turned ON.
5.2.1

MSC

[1]
[2]
Confidential – for internal use only, do not distribute
1. Turn OFF the main power switch.
2. Remove the Compact flash Cover
[1].
4040F2C596DA
3. Insert the compact flash card [2], in
which only the MSC upgrading files
have been written, into the slot.
NOTE
• Make sure that this compact flash
card contains only the upgrading
firmware of the MSC, and not that of
the engine or Finisher.
4040F2C597DA
5. Firmware upgrade
41