Legrest Slide Bushings - Permobil C400 Corpus 3G Lowrider Service Manual

Permobil C400 Corpus 3G Lowrider

Legrest slide bushings

Removal
For this task the following tools are necessary:
• 1 Allen key 3 mm.
1. Set the angle of the legrest to its outermost position.
2. Switch off the main power switch on the control
panel.
3. Remove one end of the legrest strap by carefully rais-
ing the lower section of the legrest slightly and at the
same time removing the two screws on the front of
the legrest. Pull the mounting plate out of the loop of
the strap. See fig. 145.
Once the strap is loosened the lower section of the
legrest will become loose and can be carefully pulled
downwards/forwards until the lower section of the
legrest is completely loose.
L
WARNING!
Do not subject the legrest to load during mounting
or removal. Risk of crushing.
4. Remove the slide bushing in the upper section of the
legrest, which is attached using two screws. See fig.
144.
5. Remove the slide bushing in the lower section of the
legrest, and at the same time use a suitable tool to
press in the locking tabs on the bushing, located in
the hole immediately below the top edge of the legr-
est. See fig. 143.
Mounting
1. Fit the slide bushing in the lower section of the legr-
est, making sure the locking tabs on the bushing are
securely fixed in the hole in the legrest. See fig. 143.
2. Fit the slide bushing in the upper section of the legr-
est using the two screws. See fig. 144.
3. Slide the upper and lower sections of the legrest to-
gether, and pull the legrest strap through the legrest
mechanism. See fig. 145.
4. Place the mounting plate in the loop of the strap and
then mount this on the front of the legrest using the
two screws. See fig. 145.
92
Figure 143. Slide bushing in the lower section of the
Figure 144. The slide bushing in the upper section of the
legrest is attached using two screws.
Figure 145. Strap mounting on the legrest.
legrest.
Repairs