Permobil C400 Corpus 3G Lowrider Service Manual page 46

Permobil C400 Corpus 3G Lowrider
Seat lift belt
Removal
1. Remove the seat lift - see Electric Seat lift, Page 42.
2. Remove the protective cover by gently pushing the
four plastic hooks inward. See fig. 62
3. Loosen the two screws that hold the seat lift motor's
shaft. Move the shaft sideways so that the belt be-
comes slack. See fig. 63.
4. First remove the belt from the motor shaft's cogwheel
and then from the seat lift screw's cogwheel.
Assembly and adjustment
1. First fit the belt on the seat lift screw's cogwheel and
then on the motor shaft's cogwheel.
2. Adjust the belt tension by moving the motor shaft
sideways. The belt is correctly tensioned when it can
be pressed in 4-5 mm - see fig. 63.
3. Tighten the two screws that hold the seat lift motor's
shaft - see fig. 63.
4. Check the belt tension. Adjust as required as de-
scribed in 2-3 above.
5. Refit the protective cover by gently pushing it into po-
sition making sure the four plastic hooks secure its
position. See fig. 62
6. Refit the seat lift - see Electric Seat lift, Page 42.
46
Figure 62. Seat lift protective cover.
Figure 63. The seat lift motor shaft is held in place by two
screws. The belt tension can be adjusted after the two
screws have been loosened.
Repairs