SummaCut
positioned 3 to 15 mm (0.1" to 0.6") from the media edge, will run over the sleeves
when lowered to the drive drum.
1.7.2 FEEDING AND POSITIONING MEDIA
The loading procedure described below has been found to give excellent repeatability.
When loading media, adhere to these step-by-step instructions strictly.
To load media, proceed as follows:
1.
Raise the pinch rollers by means of the pinch roller lever arm located on the
right-hand side of the cutter, next to the control panel.
2.
When working with roll media proceed by inserting a media flange at each end
of the media roll and tighten the thumbscrew until the media roll is firmly gripped
between the flanges. Make sure the flanges are firmly pressed against the roll.
Place the roll of media on the media support rollers at the rear of the machine.
3.
Position the media roll with flanges on the support rollers at the rear of the
machine.
Slide the two roll media guide bushes under the media roll so that the roll
flanges run into the groove provided in the guide bushes. In this position the
media roll and guide bushes can be shifted from the left to the right.
Start feeding the media from the rear of the machine.
Position the left media edge on the left-most drive sleeve and check whether
the right media edge is positioned over the long drive sleeve. If so, the left pinch
roller can be positioned in a detent position over the left-most sleeve and the
General Information
FIGURE 1-5:
MEDIA POSITIONING
User's Manual
1-17
Need help?
Do you have a question about the SummaCut D160SE and is the answer not in the manual?