Unit Identifier Switch/Uid Led Indicators - Supermicro X10SLA User Manual

Unit Identifier Switch/UID LED Indicators

A Unit Identifier (UID) Switch and two LED Indi-
cators are located on the motherboard. The UID
Switch is located next to the VGA port on the
backplane. The Rear UID LED (LE4) is located
next to the UID Switch. The Front Panel UID
LED is located at Pins 7/8 of the Front Control
Panel at JF1. Connect a cable to Pin 8 on JF1
for Front Panel UID LED indication. When you
press the UID switch, both Rear UID LED and
Front Panel UID LED Indicators will be turned
on. Press the UID switch again to turn off both
LED Indicators. These UID Indicators provide
easy identification of a system unit that may be
in need of service.
Note: UID can also be triggered via
IPMI on the motherboard. For more
information on IPMI, please refer to
the IPMI User's Guide posted on our
website @http://www.supermicro.com.
B
SW1
LE5
LE6
BMC
JI2C2
JI2C1
J19
J18
JPG1
JPME1
JPME2
PCH
BIOS
LICENSE
BAR CODE
MAC CODE Battery
JBT1
IPMI CODE
I-SATA0 I-SATA3
I-SATA1
SPKR1
I-SATA2
I-SATA5
BIOS
JSD1
A
USB4/5 USB2/3
VGA COM1
LAN2 LAN1
IPMI
_LAN
X10SLA(-F)
Rev. 1.01
CPU
LE3
Pin#
1
2
3
4
Color/State Status
Blue: On
A. UID SW
B. UID LED (LE4)
2-21
Chapter 2: Installation
UID Switch
Definition
Ground
Ground
Button In
Ground
UID LED
Status
Unit Identified
A