Vga Connector (Vga); Unit Identifier Switch (Uid) - Supermicro X10SRG-F User Manual

VGA Connector (VGA)

A Video (VGA/CRT) connector is
located next to COM Port1 on the I/O
backpanel. This connector is used to
provide video and CRT display.

Unit Identifier Switch (UID)

The Unit ID Switch is located near
COM2. When the Unit ID Switch is
turned on, both the blue rear Unit
ID LED and front panel Unit LED on
JF1 (if attached to the front Unit ID
LED on the chassis, see page 2-19)
will activate. Push the Unit ID Switch
again to turn off both Indicators.
These Unit ID LED Indicators provide
easy identification of the system unit,
when installed in a server cabinet for
instance. See also Unit ID LED on
page 2-19.
Pin# Definition
1 Red
2 Green
3 Blue
4 NC
5 Ground
6 Ground
7 Ground
8 Ground
9 5V
NC= No Connection
1. VGA
1
2-17
Chapter 2: Installation
VGA Pin
Definitions
Pin# Definition
10 Ground
11 NC
12 MS1: SDA (DDC Data)
13 HSYNC
14 VSYSNC
15 MS3: SCL (DDC CLK)
16 Case
17 Case