Table of Contents
Advertisement
2-4
Installing DDR3 Memory
Note: Check the Supermicro website for recommended memory mod-
ules.
Exercise extreme care when installing or removing DIMM
DIMM Installation
1. Insert the desired number of DIMMs
into the memory slots, starting with
DIMMA1 (Channel A, Slot 1, see
the next page for the location). For
the system to work properly, please
use the memory modules of the
same type and speed in the same
motherboard.
2. Push the release tabs outwards on
both ends of the DIMM slot to unlock
it.
3. Align the key of the DIMM mod-
ule with the receptive point on the
memory slot.
4. Align the notches on both ends of
the module against the receptive
points on the ends of the slot.
5. Use two thumbs together to press
the notches on both ends of the
module straight down into the slot
until the module snaps into place.
6. Press the release tabs to the lock
positions to secure the DIMM module
into the slot.
CAUTION
modules to prevent any possible damage.
Release Tabs
2-13
Chapter 2: Installation
X10SLA(-F)
Rev. 1.01
Notches
Press both notches
straight down into
the memory slot.
Advertisement
Table of Contents
