Event Logging - peplink ONE 20 User Manual

USER MANUAL
Peplink Balance Series
This setting specifies the protocol to be matched.
Via a drop-down menu, the following protocols can be specified:
Protocol
Alternatively, the Protocol Selection Tool drop-down menu can be used to automatically
fill in the protocol and port number of common Internet services (e.g., HTTP, HTTPS, etc.)
After selecting an item from the Protocol Selection Tool drop-down menu, the protocol
and port number remains manually modifiable.
This specifies the source IP address(es) and port number(s) to be matched for the firewall
rule. A single address, or a network, can be specified as the Source IP & Port setting, as
indicated with the following screenshots:
Source IP &
Port
In addition, a single port, or a range of ports, can be specified for the Source IP & Port
settings.
This specifies the destination IP address(es) and port number(s) to be matched for the
firewall rule. A single address, or a network, can be specified as the Destination IP & Port
setting, as indicated with the following screenshots:
Destination IP
& Port
In addition, a single port, or a range of ports, can be specified for the Destination IP & Port
settings.
This setting specifies the action to be taken by the router upon encountering traffic that
matches the both of the following:
Action
With the value of Allow for the Action setting, the matching traffic passes through the
router (to be routed to the destination). If the value of the Action setting is set to Deny, the
matching traffic does not pass through the router (and is discarded).
This setting specifies whether or not to log matched firewall events. The logged messages
are shown on the page Status>Event Log. A sample message is as follows:
Aug 13 23:47:44 Denied CONN=Ethernet WAN SRC=20.3.2.1
DST=192.168.1.20 LEN=48 PROTO=TCP SPT=2260 DPT=80

Event Logging

http://www.peplink.com

TCP

UDP

ICMP

IP

Source IP & port

Destination IP & port

CONN: The connection where the log entry refers to

SRC: Source IP address

DST: Destination IP address

LEN: Packet length
-178 / 269 - Copyright © 2016 Peplink