Headlamp Aim Adjustment - Victory Motorcycles Vision Tour Rider's Manual

Maintenance

Headlamp Aim Adjustment

The high beam should shine straight forward. The low beam will spread more toward the
right (U.S./Canada).
1. Verify that tire pressure is at specification. See
page 79. Verify that rear suspension ride height
(preload) is at specification. See page 68.
2. Position the motorcycle on a level surface with
the headlight approximately 25 ft. (7.6 m) from
a wall. Measure the distance from the floor to
the center of the headlight and make a mark on
the wall at the same height.
3. Sit in the operator's seat. Bring the motorcycle
to the fully upright position.
4. Move the ignition switch to the ON position and
switch the headlamp to high beam. Observe the
headlight aim on the wall. The top of the beam
should be slightly below the mark on the wall.
5. Remove the windshield trim panel. See page 85.
Reach through the opening in the headlamp housing
mount.
6. To lower the headlamp beam, turn the knob
clockwise (as viewed from the operator's seat).
7. To raise the headlamp beam, turn the knob counter-
clockwise.
90
25 ft. (7.6 m)
Center Mark
X
Knob Access
Raise
Lower