Windshield Trim Panel Removal - Victory Motorcycles Vision Tour Rider's Manual

Seat Removal / Installation
1. Open the glove compartment door and the fuel
door.
2. Lift the console trim panel straight upward at each
corner to remove it. Do not tip the panel rearward.
3. Remove the two seat bolts.
Tool: 4 mm Allen wrench
4. Unplug the seat heater power connector (if
equipped). Lift the front of the seat upward and
pull forward to disengage the tab at the rear of the
seat.
5. To install, reverse the above process, being sure to
engage the tab at the back of the seat.
6. Tighten the seat bolts.
Torque: 36 in-lbs (4 Nm)

Windshield Trim Panel Removal

Remove the windshield trim panel to access fuse
boxes, the manual windshield adjustment mechanism,
the headlamp adjustment knob and the front turn signal
bulbs.
1. Lift each panel end upward to release the ends.
2. Carefully slide the panel slightly toward the
windshield to disengage the lower tabs. Remove
the panel.
3. Unplug the antenna.
4. Reverse all steps to reinstall the trim panel.
Maintenance
Seat Bolts
36 in-lbs (4 Nm)
85