Victory Motorcycles Vision Tour Rider's Manual page 76

Maintenance
Hydraulic Clutch Fluid
1. Straddle the motorcycle and bring it to the fully
upright position. Position the handlebars so that the
fluid reservoir is level.
2. Wipe the fluid container and the area around the
reservoir cover with a clean cloth.
3. If the fluid level is low, check hoses, lines and the
slave cylinder for leaks.
4. To add fluid, remove the three reservoir cover
screws. Remove the cover and diaphragm. Carefully
add fluid to the top of the sight glass.
5. Reinstall the diaphragm, cover and screws.
Torque: 25 in-lbs (3 Nm)
6. Wipe away any fluid spills. Check for signs of fluid leaks around hoses, fittings,
reservoir, and slave cylinder. Check for deterioration of hoses.
Mechanical Clutch Lever Freeplay
1. Remove the right side access cover.
2. Hold the clutch cable and loosen the adjuster lock nut.
3. While holding the cable, turn the cable adjuster inward or
outward until clutch lever freeplay is 0.5-1.5 mm.
4. While holding the cable, tighten the adjuster lock nut
securely.
5. Reinstall the right side cover.
6. Verify that the safety switch activates properly. The
engine should not start in gear with the clutch lever
released.
Tip: The starter interlock switch is dependent on the clutch lever freeplay being set correctly to ensure
activation of the clutch safety switch.
74
Minimum
Level
0.5-1.5 mm
Freeplay