Victory Motorcycles Vision Tour Rider's Manual page 52

Operation
Fueling
Always refuel on level ground with the sidestand down. Review the fuel warnings. See page
14. Use only the recommended fuel. See page 113. Hold the nozzle while filling. Do not rest
the weight of the nozzle and hose on the filler neck. Do not leave the nozzle unattended.
WARNING! Overflows or spilled gasoline could contact a hot engine or exhaust system and cause a
fire, which could result in serious injury or death. Do not allow gasoline to contact hot components.
1. Insert the fuel nozzle 2-3 inches (5-7 cm) into the fuel tank filler neck.
2. Fill the last 1/4 tank slowly to allow the left fuel tank to fill completely. Fill the fuel tank
to a level just below the bottom of the fuel filler insert.
WARNING! Fuel expands in the fuel tank. Do not overfill. To prevent leaks, make sure the fuel filler cap
is properly seated.
NOTICE: Fuel can damage painted surfaces and plastic parts. If gasoline spills on the any part of the
motorcycle, immediately rinse it off with water or wipe it dry with a clean cloth.
Priming the Fuel System
If the motorcycle runs out of fuel, prime the fuel system before attempting to restart the
engine.
1. Fill the fuel tank.
2. Turn the ignition key to the ON position.
3. Move the engine stop/run switch from the STOP position to the RUN position.
4. Allow the fuel pump to run until it stops (about 3 seconds).
5. Move the engine stop/run switch to the STOP position and wait 10 seconds.
6. Repeat steps 3-5 four to five times.
7. Turn the key to the OFF position.
8. Start the engine. See page 51.
50