Air Filter - Victory Motorcycles Vision Tour Rider's Manual

Engine Oil / Filter Change
8. Start the engine and allow it to idle for several
minutes. Stop the engine.
NOTICE: After an oil change, the low oil pressure indicator
remains illuminated longer than usual before going
out. Revving the engine while the low oil pressure
indicator is illuminated can damage the engine.
9. Stop the engine. Check for leaks around the drain plug
and oil filter.
10. Check the oil level and adjust if needed.
11. Recycle the used oil and filter properly.
Engine Oil Capacity at Oil Change
(including filter)
Engine Oil Capacity at Oil Change
(not including filter)

Air Filter

Inspect the air filter often if riding in unusually wet or
dusty conditions. Do not apply air filter oil to this air
filter.
1. Remove the two air filter retaining screws.
2. Pull the lower edge of the filter toward the front
of the motorcycle, then lower it to release the two
tabs at the top edge. Remove the filter.
3. Clean the filter sealing surface on the frame.
4. Install the new air filter, engaging the tabs at the
top of the filter with the filter case.
5. Reinstall the retaining screws.
Torque: 87 in-lbs (10 Nm)
4.5 qt. (4.25 liter)
(approximately)
4.0 qt. (3.8 liter)
(approximately)
Screws
Maintenance
Oil Check/Fill
1 qt. (.9 l)
(approximately)
Tabs
63